Subaru 2006 Legacy, Manual

Page: 397 / 4302

EN(H4SO)(diag)-3 8
Inspection Mode
ENGINE (DIAGNOSTICS)
5) Start the engine.
NOTE:
• Make sure the select lever is placed in “P” posi-
tion before starting. (AT model)
• Depress the clutch pedal when starting engine.
(MT model)
6) Using the selector lever or shift lever, turn the P
position switch and N position switch to ON.
7) Depress the brake pedal to turn the brake switch
ON. (AT model)
8) Keep the engine speed in 2,500 — 3,000 rpm
range for 40 seconds.
9) Place the select lever or shift lever in D position
(AT model) or 1st gear (MT model) and drive the
vehicle at 5 to 10 km/h (3 to 6 MPH).
NOTE:
• For AWD model, release the parking brake.
• The speed difference between front and rear
wheels may light the ABS warning light, but this in-
dicates no malfunctions. When engine control diag-
nosis is finished, perform the ABS memory
clearance procedure of self-diagnosis system.
10) Using the general scan tool, check for DTC and
record the result(s).
NOTE:
• For detailed operation procedure, refer to the
general scan tool operation manual.
• For details concerning DTC, refer to “List of Diag-
nostic Trouble Code (DTC)”.
<Ref. to EN(H4SO)(diag)-70, List of Diagnostic
Trouble Code (DTC).>
asieps_tobira.book 38 ページ ２００９年１０月２６日 月曜日 午前９時１６分