Subaru 2006 Legacy, Manual

Page: 2706 / 4302

EN(H6DO)(diag)-33
Subaru Select Monitor
ENGINE (DIAGNOSTICS)
7. LED OPERATION MODE FOR ENGINE
1) On the «Main Menu» display screen, select {Each System Check} and press the [YES] key.
2) On the «System Selection Menu» display screen, select {Engine Control System} and press the [YES]
key.
3) Press the [YES] key after the information of engine type has been displayed.
4) On the «Engine Diagnosis» display screen, select the {Current Data Display/Save}, and then press the
[YES] key.
5) On the «Data Display» screen, select the {Data LED Display} and press the [YES] key.
6) Using the scroll key, scroll the display screen up or down until the desired data is shown.
• A list of the support data is shown in the following table.
NOTE:
For detailed operation procedure, refer to the “SUBARU SELECT MONITOR OPERATION MANUAL”.
Remarks Display Message When LED “ON” is required
Test mode signal Test mode terminal D check/U check D check
Neutral position switch signal Neutral SW Neutral/Other than neutral Neutral
Idle switch signal Soft Idle SW Idle/Other than idle In idle
Ignition switch signal Ignition SW ON Input/OFF Input ON input
Power steering switch signal Power steering SW ON Input/OFF Input ON input
Air conditioning switch signal A/C SW ON Input/OFF Input ON input
Starter switch signal Starter SW ON Input/OFF Input ON input
Front oxygen monitor 1 FtO2 monitor 1 Lean/Rich Rich
Front oxygen monitor 2 FtO2 monitor 2 Lean/Rich Rich
Knocking signal Knock Signal Yes/No Yes
Crankshaft position sensor signal Crankshaft angle signal Yes/No Yes
Camshaft position sensor signal Camshaft angle signal Yes/No Yes
Rear defogger switch signal Rear Defogger SW ON Input/OFF Input ON input
Blower fan switch signal Blower fan SW ON Input/OFF Input ON input
Light switch signal Light SW ON Input/OFF Input ON input
Air conditioning lock signal A/C lock signal ON Input/OFF Input ON input
A/C middle pressure switch signal A/C middle pressure SW ON Input/OFF Input ON input
Air conditioner compressor relay signal Compressor relay ON output/OFF output ON output
Pressure control solenoid valve signal PCV Solenoid ON or OFF
When pressure control valve
is ON.
Drain valve signal Vent Control Solenoid ON or OFF When drain valve is ON.
AT retard angle demand signal AT retard angle demand Yes/No Yes
AT fuel cut signal AT fuel cut Yes/No Yes
VDC torque down prohibition output Torque down output ON/OFF Prohibition
VDC torque down demand Torque down demand Yes/No Yes
AT coordinate permission signal
AT coordinate permission
signal
ON/OFF Permission
Electronic throttle control motor relay sig-
nal
ETC motor relay ON/OFF ON
Stop light switch signal Stop SW ON Input/OFF Input ON input
SET/COAST switch signal SET/CST SW ON Input/OFF Input ON input
RESUME/ACCEL switch signal RES/ACC SW ON Input/OFF Input ON input
Brake switch signal Brake SW ON Input/OFF Input ON input
Main switch signal Main SW ON Input/OFF Input ON input
Body integrated unit data reception Body Int. Unit Data Yes/No Yes
Body integrated unit counter update Body Int. Unit Count Yes/No Yes
Cruise control cancel switch signal CC Cancel SW ON Input/OFF Input ON input
asieps_tobira.book 33 ページ ２００９年１０月２６日 月曜日 午前９時１６分