Subaru 2006 Legacy, Manual

Page: 3956 / 4302

DS-14
Front Axle
DRIVE SHAFT SYSTEM
11) Remove the bolts which secure the sensor har-
ness to the strut.
12) Remove the front arm ball joint from the hous-
ing.
13) Remove the PTJ from transmission.
14) Remove the front drive shaft assembly from the
hub. If it is hard to remove, use the ST.
ST1 926470000 AXLE SHAFT PULLER
ST2 28099PA110 AXLE SHAFT PULLER
PLATE
15) After scribing an alignment mark on camber ad-
justing bolt head, remove the bolts which connect
the housing and strut, and disconnect the housing
from strut.
B: INSTALLATION
1) Align the alignment mark on the camber adjust-
ing bolt head, and tighten the housing and strut us-
ing a new self-locking nut.
Tightening torque:
152 N·m (15.5 kgf-m, 112.1 ft-lb)
2) Install the front drive shaft. <Ref. to DS-22, IN-
STALLATION, Front Drive Shaft.>
3) Install the front arm ball joint to the housing.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
4) Install the ABS sensor harness to the strut.
5) Install the ABS wheel speed sensor on the hous-
ing.
Tightening torque:
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
6) Install the disc rotor to hub.
7) Install the disc brake caliper on the housing.
Tightening torque:
80 N·m (8.2 kgf-m, 59 ft-lb)
8) Install the stabilizer link.
9) Connect the tie-rod end ball joint to the knuckle
arm with a castle nut.
Tightening torque:
27.0 N·m (2.75 kgf-m, 19.9 ft-lb)
CAUTION:
When connecting the tie-rod, do not hit the cap
at bottom of tie-rod end with a hammer.
DS-00144
DS-00045
DS-00145
ST2
ST1
DS-00046
asieps_tobira.book 14 ページ ２００９年１０月２６日 月曜日 午前９時１６分