Subaru 2006 Legacy, Manual

Page: 4018 / 4302

PS-4 8
Oil Pump
POWER ASSISTED SYSTEM (POWER STEERING)
• Turbo model
4) Connect the power steering pressure switch
connector.
5) Install the V-belts to the oil pump.
6) Check the tension of the V-belt.
<Ref. to ME(H4SO)-37, INSPECTION, V-belt.>
7) Tighten the belt tension bolt.
Tightening torque:
25 N·m (2.5 kgf-m, 18.4 ft-lb)
8) Install the pulley belt cover.
9) Install the air intake duct.
<Ref. to IN(H4DOTC)-9, INSTALLATION, Air In-
take Duct.> <Ref. to IN(H4SO)-8, INSTALLATION,
Air Intake Duct.>
10) Connect the ground cable to battery.
11) Fill with the specified power steering fluid.
<Ref. to PS-54, Power Steering Fluid.>
CAUTION:
Never start the engine before filling with fluid;
otherwise the vane pump may become seized.
2. H6 MODEL
1) Install the oil pump to bracket.
(1) Place the oil pump bracket in a vise. Tighten
the bushing using a 12.7 mm (1/2
″
) type 14- and
21- mm box wrench until it is in contact with the
oil pump mounting surface.
CAUTION:
When securing the oil pump bracket in a vice,
hold the oil pump bracket with the least possi-
ble force between two pieces of wood.
(2) Tighten the bolt which attaches the oil pump
to the bracket.
Tightening torque:
15.7 N·m (1.6 kgf-m, 11.6 ft-lb)
Tightening torque:
37.3 N·m (3.8 kgf-m, 27.5 ft-lb)
(1) Suction hose
(2) Pressure hose
(2)
PS-00459
(1)
(1) Bushing
(2) Nut
(3) 21 mm
(4) 14 mm
(5) Bolt
PS-00135
PS-00229
PS-00702
asieps_tobira.book 48 ページ ２００９年１０月２６日 月曜日 午前９時１６分