Subaru 2006 Legacy, Manual

Page: 3733 / 4302

5MT-6 8
Front Differential Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL
2) Remove the oil seal.
NOTE:
Do not reuse the oil seal. Replace the oil seal with
a new part.
D: ASSEMBLY
1. DIFFERENTIAL CASE ASSEMBLY
1) Install the bevel gear and bevel pinion together
with washers, and insert the pinion shaft.
NOTE:
Face the chamfered side of washer toward gear.
2) Measure the backlash between the bevel gear
and pinion. If backlash is not within specified value,
install a suitable washer to adjust. <Ref. to 5MT-70,
ADJUSTMENT, Front Differential Assembly.>
NOTE:
Be sure the pinion gear teeth contacts adjacent
gear teeth during measurement.
ST1 498247001 MAGNET BASE
ST2 498247100 DIAL GAUGE
Standard backlash
0.13 — 0.18 mm (0.0051 — 0.0071 in)
3) Align the pinion shaft and differential case with
each hole, and drive the straight pin into the holes
from the hypoid driven gear using the ST.
NOTE:
Lock the straight pin after installing.
ST 899904100 REMOVER
4) Install the roller bearing to differential case.
NOTE:
• Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
• Be careful because the roller bearing outer races
are used as a set.
ST1 499277100 BUSHING 1-2 INSTALLER
ST2 398497701 ADAPTER
(A) Bevel pinion
(B) Bevel gear
(C) Pinion shaft
MT-01003
MT-00284
(A)
(B)
(C)
(A) Pinion shaft
(B) Differential case
(C) Straight pin
MT-00285
ST1
ST2
MT-00286
(A)
(C)
(B)
MT-00287
ST1
ST2
asieps_tobira.book 68 ページ ２００９年１０月２６日 月曜日 午前９時１６分