Standard Horizon CP390i, Owner'S Manual

Page: 78 / 168

CP390i and CPF390i Page 79
WAAS 3D
WAAS 3D
Figure 9.2 - Olympic Route creation (1)
7. Press [O
LYMPIC
] . A line joins the starting Waypoint and the last Waypoint.
WAAS 3D
WAAS 3D
Figure 9.2a - Olympic Route creation (2)
9.3 MAKING ADDITIONAL ROUTES
To create another Route the GPS Chart Plotter must be told that you want to create a second
Route.
1. Press
[MENU] , move the ShuttlePoint knob to highlight USER POINTS and press
[ENT] .
2. Move the ShuttlePoint knob to highlight ROUTE and press [ENT] .
3. Move the ShuttlePoint knob to highlight SELECT and press [ENT] or move the
ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to an open Route number example Route 2.
5. Press
[ENT] or move the ShuttlePoint knob to the right.
6. Press [CLR] or move the ShuttlePoint knob to the left until the Chart page is shown.
7. To create the new Route, follow the steps in Creating a Route using Waypoints or Marks
sections.
9.4 CREATING A ROUTE USING MARKS ON THE CHART PAGE
To create a Route containing Marks you first must create the Marks and show them on the
Chart page.
1. Move the ShuttlePoint knob over the top of a Mark that you wish to be the starting point
in the Route and press [ROUTE] .
2. Next move the ShuttlePoint knob until the cursor is over the Mark that you want to be
the next leg in the Route.
3. Press [ROUTE] . You will notice a bearing line joins the first and second Mark which
means these Marks are selected into the Route.
4. Repeat steps 3 and 4 until all Marks are entered into the Route.
NOTE
At this point the Route is saved as ROUTE01. If you would like to save the Route under a specific
name follow the remaining steps.