Standard Horizon CP390i, Owner'S Manual

Page: 117 / 168

Page 118 CP390i and CPF390i
become active within this range. Activation Range should be greater than CPA Limit
by definition.
NOTE
A target is removed from the screen if data is not received for 10 minutes.
The maximum number of tracked Class A or B targets is 200.
This information is updated every 3 seconds to 6 minutes depending on speed and rate of turn,
enabling the track of the vessels in range to be plotted.
Figure 14.0 - AIS Symbols
14.1 MENU
To configure the GPS Chart Plotter to receive AIS data, follow the procedure:
1. Press
[MENU] , move the ShuttlePoint knob to highlight SETUP MENU and press [ENT] .
2. Move the ShuttlePoint knob to highlight AIS SETUP and press [ENT] or move the
ShuttlePoint knob to the right. The new AIS menu appears on the screen. The available
functions are described in the following table.
Display : Turns the display of AIS Targets overlay on the cartography On or Off. The default setting is On.
Activation Range : Defines the range from the fix within which the AIS Target becomes active. The values allowed
are from 0.1 to 20 Nm. The default setting is 5 Nm.
CPA Alarm : Turns On or Off the alarm. The default setting is On.
CPA Limit : The values allowed are from 0.1 to 10 Nm. The default setting is 0.5 Nm.
TCPA Alarm : Turns On or Off the alarm. The default setting is On.
TCPA Limit : The values allowed are from 1 to 30 Min. The default setting is 10 Min.
14.2 AIS SETUP
Refer to Par. 2.4 for connections.
14.3 QUICK INFO ON AIS TARGET
By placing the cursor over a AIS Target icon using the ShuttlePoint knob, the following
information is displayed (see the following picture):
· Vessel Name
· MMSI number
· Radio Call Sign
· SOG
· COG
· CPA and TCPA values