Standard Horizon CP390i, Owner'S Manual

Page: 21 / 168

Page 22 CP390i and CPF390i
2.4.1.1 Connection a VideoCamera, FF525, AIS receiver, VHF and Autopilot
ACC 2 Cable - Not used
CP390i
Optional
WAAS GPS
Antenna
VIDEO
Camera
Battery
10-35Vdc
Red
2A
Fuse
Black
Switch
+
-
VHF
PILOT
Green
Blue
Brown
Gray
White
Yellow NMEA Common
Port 1 Input
Port 1 Output
Port 2 Input
Port 2 Output
Port 3 Output
PWR & ACC 1 Cable
AIS
VIDEO
Camera
ACC 2 Cable
Red
Black
Green
Blue
Brown
Gray
White
Yellow No Connection
No Connection
NMEA Common
Port 4 Input
Port 4 Output
Port 5 Input
Port 5 Output
No Connection
AIS
Battery
10-35Vdc
Red
2A
Fuse
Black
Switch
+
-
Tee
Optional
Fish Finder
VHF
PILOT
Green
Blue
Brown
Gray
White
Yellow NMEA Common
Port 1 Input
Port 1 Output
Port 2 Input
Port 2 Output
Port 3 Output
PWR & ACC 1 Cable
Transducer
CP390i
Optional
WAAS GPS
Antenna
NOTE
Port2 Input and Output is used by the optional FF525. In the diagram above you will notice Port2
Input and Output wires are shown in gray and not used.
Port4, and 5 Outputs are can be connected to NMEA devices*capable of listening to NMEA0183
sentences.
Port4, and 5 Inputs can be connected to NMEA devices* capable of outputting to NMEA0183
sentences.
The Input and Output baud rate for each Port is set using the Advanced
Setup>In/Out Connections menu. For example if Port1 is set for AIS 38400, the
Input Port operates at 38400 baud and the Output Port is disabled.
NOTE*
RS232 not opto-isolated electrical interface .
2.4.1.2 AIS Setup
The CP390i has to be set up to be able to receive NMEA information from the AIS receiver.