Sony MG40 Series, Command Reference Manual

Page: 79 / 140

(E)
2-3
MG40 Series
2-3. Initial Setting Procedure
Th e following initial settings must be established without fail aft er installation.
Th ese settings must be established aft er the connection to the command interface has been completed.
(Refer to “2-2-1. Connection to the Command Interface” .)
Setting the area where the system is to be used
1
<If the system is to be used in Japan>
Input the following command:
CTR=1 CR LF
<If the system is to be used in any other country>
Input either of the following commands: (For details, refer to “Area of use.”)

CTR command
CTR=2 CR LF
CTR=3 CR LF
...... When the command has been input successfully, the following is returned:
OK000 CR LF
Setting the IP address
2
Refer to the example given below, and set the IP address that corresponds to the network which will be
used.
<Example> When setting the IP address to 192.168.1.10
Input the following command:
NIP=192.168.1.10 CR LF
...... When the command has been input successfully, the following is returned:
OK000 CR LF
Th is now completes the initial settings.

Th ere is no need to set again the area where the system is to be used unless the settings have been
initialized.

Th e new IP address setting will be refl ected the next time the unit is started up.
<Concerning command return errors>
If a return starting with ER is sent instead of OK000 aft er a command has been sent, it means that an error
has occurred.
(Refer to
“6. Error Codes” .)
Return Description of error Checkpoint
ER210 Possible command recognition error Are the command format and its alphabet letters correct?
ER214 Possible parameter error Is the numerical value following the equals sign correct?
If a return is not sent even when a command has been sent, it is possible that the “no response” has been
set as the command response. When “response” is set using the command response command (CRP), a
return will be sent.

CRP command
Reference Reference