Sony MG40 Series, Command Reference Manual

Page: 78 / 140

2-2
(E)
MG40 Series
2-2. Connection to the Ethernet Interfaces
2-2-1. Connection to the Command Interface
Take the following steps to connect to the command interface.
1
Connect the MG41 main unit to the computer or PLC using an Ethernet cable.
2
Establish the connection settings below.
Protocol telnet
IP address IP address which has been set
(

)
(factory setting: 192.168.1.100)
Port number TCP #23
Line feed code
CR LF
(

)
If the IP address which has been set is not known, set SW8 among the communication setting
switches on the side panel of the MG41 main unit to ON, and then restart the unit. By doing this, it is
temporarily possible to connect to 192.168.1.100 which was the address set at the factory. (Refer to “9.
Troubleshooting” in the operating instructions.)
3
Connect to the command interface.
When connection is made to the command interface, a login prompt such as the one shown in the
fi gure below is output from the MG41 main unit.
login:
4
Input “MG41” as the login name, and transmit the line feed code.
login: MG41 CR LF
“Password:” now appears.
Password:
5
Input MG41 as the password, and transmit the line feed code.
login: MG41 CR LF
Password: MG41 CR LF
Th is completes the connection to the command interface.
Reference Reference