EM330D User Manual
A Special Purpose Inverter for Hoisting
69
Multi-function input terminals X1
～
X7 are 7 programmable numeric input terminals. The
function of X1~X7 can be defined by the setting value of F2-00
～
F2-06.
For example, set F2-00=1, then the function of terminal X1 is RUN. If start/stop control
mode is in terminal control mode, and then when terminal X1 is on, inverter runs.
Xi=0
No function
This function can be used to block the terminal when its hardware breaks down.
Xi=1
RUN
When start/stop control mode is terminal control (F0-04=1), if the function terminal is on,
the inverter will run as per the setting value of F0-05.
Xi=2
F/R Forward/Reverse
When start/stop control mode is in terminal control mode (F0-04=1), if the function
terminal is on, the inverter will forward/reverse as per the setting value of F0-05.
Xi=3
Preset Speed Terminal 1
Xi=4
Preset Speed Terminal 2
Xi=5
Preset Speed Terminal 3
Xi=6
Preset Speed Terminal 4
In preset speed control mode, define 4 function input terminals as the preset speed terminals.
A preset speed set in F3-00
～
F3-14 is selected as the present setting frequency of inverter
by the programming coding of these 4 terminals. See 7.4 for preset speed options setting.
Xi=7
Acceleration/Deceleration Time Terminal 1
Xi=8
Acceleration/Deceleration Time Terminal 2
F0-09
，
F0-10
，
F3-15
～
F3-20 set acceleration/deceleration time 1
～
4, and select
corresponding
acceleration/deceleration
time
1
～
4
through
programming
acceleration/deceleration terminals. See 7.3 for the correlation of acceleration/deceleration
time and its terminal.
Xi=9
Coast to stop
Inverter is running, if the function terminal is on, PWM output is blocked immediately, and
then motor coasts to stop.
Xi=10
Inverter fault reset input
Inverter can be reset through fault reset terminal after inverter fault is cleared.
Xi=11~25
Not apply to hoisting
