Appendix
A.2 Configuration record
AT40, ATD400V, ATD400K, ATD4xxW, ATD400S, ATE250S, ATD400T
System Manual, 06/2016, A2B00096162-AN
327
Note
Parameter changes
Parameters should always be adjusted during normal operation with the door in the
CLOSED position, because the controller then accepts the values immediately.
Parameter
Unit
Set value
Creep distance OPEN
mm
Cutter distance OPEN
mm
Creep distance CLOSE
mm
Cutter distance CLOSE
mm
Maximum speed OPEN
mm/s
Creep speed OPEN
mm/s
Cutter speed OPEN
mm/s
Initial speed OPEN
mm/s
Maximum speed CLOSE
mm/s
Creep speed CLOSE
mm/s
Cutter speed CLOSE
mm/s
Initial speed CLOSE
mm/s
Nudge speed/
NDG speed (reduced)
1)
mm/s
Acceleration ramp OPEN
mm/s
2
Braking ramp OPEN
mm/s
2
Reversing ramp OPEN/CLOSE
mm/s
2
Acceleration ramp CLOSE
mm/s
2
Braking ramp CLOSE
mm/s
2
Reversing ramp CLOSE/OPEN
mm/s
2
Continuous torque (power) OPEN
A
Continuous torque (power) CLOSE
A
Cutter press-on torque
A
Static opening force
N
Static closing force
N
Static cutter force CLOSE
N
Static nudge force CLOSE /
Static NDG force (reduced)
1)
N
Special parameters for SIDOOR ATD400K
Hold-open time standard
s
Hold-open time cord-operated switch
s
Opening width as a percentage
%
