12-6
12
Other Settings and Operations
(3) Operating procedure
On the [ADJ. CAM POSITION] (camera position adjustment) menu, store the data needed for
later adjustment (before a camera is replaced or dislocated), and then adjust the camera position
(after the camera is replaced or dislocated).
Storing the data needed for adjustment (before a camera is replaced or dislocated)
1. Set the image conditions for adjustment before replacement (window position and threshold
value after binary conversion).
- Set these conditions in items
2
,
3
and
4
on the [ADJ. CAM POSITION] (camera position
adjustment) menu. (Set the conditions in the freeze display mode.)
2. Store a binary image for rough adjustment.
3. Store the characteristic parameters
(center of gravity and fillet diameter) of a binary image
for dimensional and positional adjustment.
4. Store the average light level for brightness adjustment.
5. You can check the stored values for center of gravity, fillet diameter and average light level in
item
9
.
6. If the number of labels exceeds the maximum number of labels which can be stored 32, use an
area filter.
7. You can check the centers of gravity, fillet diameters and average light levels of each label from
No. 1 up to the maximum number, using the up and down keys.
Go to the next page
6
7
5
2~4
1
1
SELECT A CAMERA
CAM1(1~2) NO
YES
2
WINDOW POSITION
MOVE UP.L(224,208) LO.R(287,271)
3
THRESHOLD VALUE U.LM-255 L.LM-100(0~255)
4
INVERT B/W
NO
YES
5
AREA FILTER
000000 PIXEL LOWER LIMIT
6
DISP DEG OF MATCH (SET KEY)
7
INTIAL CAM IMG
REG.
LABL10
8
IMG AFTR CAM CHNG
(SET KEY)
9
DISPLAY LABELS LABL00 BER.CHG AFT.CHG
GRAVTY X 310.0
GRAVTY Y 220.0
FILLET X 040
FILLET Y 032
AV-L.LVL 100.5
0
UPPER MENU
[ADJ. CAM POSITION]
When the data has been
stored (the SET key is
pressed), the number of
labels will be displayed.
On the [MAIN OPS MENU], move the cursor to SET-SCRN, and press the SET key.
-
On the [SYSTEM SET UP] menu, move the cursor to item
4
ADJ. CAM POSITION (camera position
adjustment) and press the SET key.
-
On the [ADJ. CAM POSITION] menu, set item
1
SELECT A CAMERA to YES.
Store all of the conditions
by going to item
7
on
the [ADJ. CAM
POSITION] menu.
(Store them in the freeze
display mode.)