9-28
Shared settings
9
1
3
2
4
[OBJECT TYPE COND]
1
OBJECT TYPE NO.
00(0~15)
2
EDIT
COPY(
←OBJ
TYPE00) INITIALIZE
3
TITLE REGISTRATION (TO NEXT SUB-MENU)
4
MEAS.0, CAMERA1
NO (TO NEXT SUB-MENU)
5
POS. ADJ.CAMERA1
NO ADJ. [REG. 0-1PNTSXY
]
6
MEAS.0, CAMERA2
NO (TO NEXT SUB-MENU)
7
POS. ADJ.CAMERA2
NO ADJ. [REG. 0-1PNTSXY
]
8
SELECT CAMERA IMG NO CAM1 CAM1 CAM1&2
9
COMPARE IMAGES
NO
SUB.I1
−
T1 DIFF.ABS
|
I1
−
T1
|
0
MEASUREMENT 1
NO (TO NEXT SUB-MENU)
q
MEASUREMENT 2
NO (TO NEXT SUB-MENU)
w
MEASUREMENT 3
NO (TO NEXT SUB-MENU)
e
FINAL CALC RESULT
(TO NEXT SUB-MENU)
r
FINAL OUTPUT COND (TO NEXT SUB-MENU)
t
SYSTEM-IN/OUT
(TO NEXT SUB-MENU)
y
HALT MEAS ON NG
NO
YES
u
UPPER MENU
· Item
9
COMPARE IMAGES (calculation between
images) will be displayed unless item
8
SELECT
CAMERA IMG is set to NO.
On the MAIN OPS MENU, move the cursor to SET-SCRN item, and press the SET key.
-
On the [SYSTEM SETUP] menu, move the cursor to
2
OBJECT TYPE COND
(condition of object type) and press the SET key.
- Do not disconnect the power while the IV-S20 is copying.
- Once data has been corrupted it will be necessary to start after initializing the setting, all over
again. Unless this is done it will not be possible to restart the machine.
- The reference images used for the gray scale seach function are not copied with the
operation above. Make sure reset them.
Notes
[7] Copying (editing)
When there are many common parameters between measurement programs or object types, it is
most efficient to access those existing sets of parameters in order to copy and then modify them.
- There are two types of copy functions on the IV-S20: Copying between object types and copying
between measurement programs.
(1) Copying between object types
The parameters of a previously specified object type are copied into another object type, after
which they can be modified.
[Operation procedure]
1. Select item
1
OBJECT TYPE NO., using the up and down keys and press SET key.
2. Using the up and down keys, enter the object type number (00 to 15) for the target of the copy.
3. Select item
2
EDIT, using the up and down keys and press SET key.
4. Move the cursor to COPY (copying) using the left and right keys and enter the object type
number (00 to 15) for the source of the copy using the up and down keys. When the number
has been selected, press SET key.
- While something is being copied, the message [COPYING] will appear at the top of the
screen. This message will disappear when the copying is complete.
The measurement conditions of
the source object type. (The data
is copied from flash memory)
The measurement conditions of the target
object type. (The data is used to simplify
setting the target object's parameters)
The source of the copy
The target of the copy