9-100
Object identification (labeling) by binary conversion
9
1
REGST NO.
(registration number )
2
BINARY AREA COND
(condition for binary areas)
3
FIND CENT/GRAVITY
(center of gravity
measurement)
4
MAIN AXIS ANGLE
5
FILLET DIAMETER
(fillet width)
6
PERIMETER LENGTH
(circumference)
Mesurement conditions
Set this to any number from 0 to 3 and select NO or
YES to store it.
Setting details
- Select LABEL-BIN-OBJ (object identification by binary conversion) in
item
1
.
- Item
2
will be displayed unless NO is selected in item
8
SELECT CAMERA IMG
(camera selection) which is in the [OBJECT TYPE COND] (conditions of object type)
menu.
Continued on the following page
Select item
6
MEAS.PROG.COND (conditions for measurement programs).
Select item
2
BINARY AREA COND (conditions for binary areas).
On the MAIN OPS MENU, move the cursor to SET-SCRN, and press SET key.
-
On the [SYSTEM SETUP] menu, move the cursor to
2
OBJECT TYPE COND (conditions of
object type) and press the SET key.
-
Select item
0
MEASUREMENT 1,
q
MEASUREMENT 2 or
w
MEASUREMENT 3
on the [OBJECT TYPE COND] menu .
[TYPE00-MEAS1]
1
MEAS SELECTION NO
CHECK-DEG-OF-MATCH
DST&AGL MES. (GRAY&EDGE GRAV)
INSPECT-LEAD MEASR-BIN-AREA
CNT-BIN-OBJ LABEL-BIN-OBJ
POINT MEAS
2
COMPARE IMAGES NO YES(CAM1)
3
SELECT CAMERA CAM1
CAM2
4
COPY
EXEC
←
TYPE00
−
MEAS1
−
NO
5
INITIALIZATION
EXEC
6
MEAS.PROG. COND (TO NEXT SUB-MENU)
7
EVALUATION COND (TO NEXT SUB-MENU)
8
NUMERIC CALC COND (TO NEXT SUB-MENU)
9
OUTPUT CONDITIONS (TO NEXT SUB-MENU)
0
UPPER MENU
- If YES was specified in item
1
REGST NO. (registration number), then items
2
to 6 will be
displayed.
[MEASURING COND] (TYPE00-MEAS.1-LABEL-BIN-OBJ)
1
REGST NO.
00(0~3) REG.NO
YES
2
BINARY AREA COND (TO NEXT SUB-MENU)
3
FIND CENT/GRAVITY NO
YES
4
MAIN AXIS ANGLE NO
YES
5
FILLET DIAMETER NO
YES
6
PERIMETER LENGTH NO
YES
7
UPPER MENU
This will return you to the [TYPE00-MEAS1 to 3] menu.
Select YES/NO for each of the measurements.
-
See page 9Æ102.
The conditions for binary areas are set on the next
menu.
7
UPPER MENU
This is how the line
looks when the ob-
ject type is set to
00 and the selec-
ted measurement
is 1.
[2] Setting details
An explanation of the
6
MEAS.PROG.COND (conditions for measurement programs) from the
[TYPE00-MEAS1 to 3] (object type measurement) menu.