2
Safety notes
Transport
Operating Instructions – Compact Extra-Low Voltage Drives
9
2.5
Transport
Inspect the shipment for damage as soon as you receive the delivery. Inform the ship-
ping company immediately about any damage. If the product is damaged, it must not
be assembled, installed or started up.
Observe the following notes when transporting the device:
• Ensure that the product is not subject to mechanical impact.
If necessary, use suitable, sufficiently dimensioned handling equipment.
Observe the information on climatic conditions in chapter Technical data of the docu-
mentation.
2.6
Installation/assembly
Ensure that the product is installed and cooled in accordance with the regulations in
the documentation.
Protect the product from excessive mechanical strain. The product and its mounted
components must not protrude into the path of persons or vehicles. Ensure that no
components are deformed or no insulation spaces are modified, particularly during
transportation. Electrical components must not be mechanically damaged or de-
stroyed.
Observe the notes in chapter Mechanical installation in the documentation.
2.6.1
Restrictions of use
The following applications are prohibited unless the device is explicitly designed for
such use:
• Use in potentially explosive atmospheres
• Use in areas exposed to harmful oils, acids, gases, vapors, dust, and radiation
• Operation in applications with impermissibly high mechanical vibration and shock
loads in excess of the regulations stipulated in EN 61800-5-1
•
Use at an elevation of more than 4000 m above sea level
The product can be used at altitudes above
1000
m above sea level up to
4000
m
above sea level under the following conditions:
• The reduction of the nominal output current and/or the line voltage is considered
according to the data in chapter Technical data in the documentation.
• Above
2000
m above sea level, the air and creeping distances are only sufficient
for overvoltage class II according to
EN
60664. At altitudes above
2000
m above
sea level, limiting measures must be taken which reduce the line side overvoltage
from category III to category II for the entire system.
• If a protective electrical separation (in accordance with
EN 61800‑5‑1
and
EN 60204‑1)
is required, then implement this outside the product at altitudes of
more than 2000 m above sea level.
26718014/EN – 11/2020
