Servomex 07931001B, Operator'S Manual

Page: 81 / 221

07931001B revision 6 © Servomex Group Limited. 2020
67
4.9 X-Interference offset
The X-Interference offset can be used to offset the measurement proportional to the
concentration of an interfering background gas.
The offset can only be set to a maximum of +/-10 and should only be
used for % level measurements. Care should be taken using this
function of other units of measurement.
X-Interference offset should only be set after consultation with
Servomex and only after an application review has been carried out.
.
To set the X-interference offset
Figure 4-28: X - interference configuration menu
4.10 Clipping
When enabled, clipping is applied to all instances of a measurement, including
displayed values, mA output values and values accessible through digital
communications.
To set up clipping
Figure 4-29: Set up Clipping menu
Menu Set Up X-Interference 1 XXX X-Interference
Calibrate Manage Analyser 1 Measurement (1) Offset
Data Log mA Input 2 Trans
Alarms mA Output 0.0000 Edit value
Status Relay Setup
Set Up Filtering
Measurements Unit Select
Service X-Interference
Clipping
User Settings
Menu Set Up Clipping Clipping 1 XXX Clip High
Calibrate
Manage Analyser
1 Measurement (1) Clip High Clip High
Data Log mA Input 2 Trans Clip Low
Alarms mA Output Disabled
Status Relay Setup
Set Up Filtering
Measurements Unit Select
Service X-Interference
Clipping
User Settings
1 XXX Clip High
Clip Level
Enabled
Disabled