Servomex 07931001B, Operator'S Manual

Page: 152 / 221

138
© Servomex Group Limited. 2020 07931001B revision 6
Do not apply power to the transmitter unit before both the transmitter
and receiver units are fitted to the Analyzer flanges and front panels have
been closed. This ensures that there is no risk of exposure to laser light.
Make sure that there is enough space at the base and sides of the
enclosure to open the covers and to route cables and pipework without
tight bends.
Note: Although the following diagrams show the TU, use the same technique for the
RU.
Check the O-ring is in place on the transmitter / receiver flange before
installation.
Loosen the 3 x M6 screws and align them with the corresponding keyhole slots on
the flange joint (Figure 7-11).
Figure 7-11: Align M6 screws with the flange joint