Servomex 07931001B, Operator'S Manual

Page: 122 / 221

108
© Servomex Group Limited. 2020 07931001B revision 6
Register Name M1
Address
M2
Address
Read/
Write
Notes
that there is span-gas in the cell which may
give incorrect measurements
If this flag is set, it can be cleared by doing a
complete auto val with the cell being
successfully purged at the end.
Debug message 50007 50087 R Reading this address causes some debug
information to be printed to the system log.
This is for Servomex use only.
Auto Val supported for
this measurement 50008 50088 R 0 = Auto val not supported
1 = Auto val supported
Correct password
received 50009 50089 R 0 = password not received
1 = password received - auto val is now
enabled
Requested zero-gas
state 50024 50104 R The analyzer uses this address to tell the HMI
when to turn the zero-gas on or off. The HMI
should monitor this register and set the zero-
gas state accordingly
0 = HMI should turn off zero-gas
1 = HMI should turn on zero-gas
Requested span-gas
state 50025 50105 R The analyzer uses this address to tell the HMI
when to turn the span-gas on or off. The HMI
should monitor this register and set the span-
gas state accordingly
0 = HMI should turn off span-gas
1 = HMI should turn on span-gas
Set Stability Time 50026 50106
R/W The measurement must be within the stability
criteria for this length of time before taking a
zero or span measurement. Unit = sec
Set Flush Time 50027 50107
R/W Allow the zero or span-gas to flush through for
this length of time before looking for a stable
zero or span measurement. Unit = sec
Set Timeout 50028 50108 R/W If the measurement is not stable after this
length of time, carry on with auto validation
regardless. Unit = sec
set validation pressure 50041 50121 R/W set validation pressure for auto val on
measurement 1
set validation
temperature 50043 50123 R/W set validation temperature for auto val on
measurement 1
set validation gas
concentration 50045 50125 R/W set validation gas concentration for auto val on
measurement 1
set validation gas
tolerance 50047 50127 R/W set validation gas tolerance for auto val on
measurement 1
set validation pass level 50049 50129 R/W set validation pass level for auto val on
measurement 1
set validation cell
length 50051 50131 R/W set validation cell length for auto val on
measurement 1
set validation
concentration standard
deviation tolerance 50053 50133 R/W
set validation concentration standard deviation
tolerance for auto val on measurement 1
set validation
transmission standard
deviation tolerance 50055 50135
R/W set validation transmission standard deviation
tolerance for auto val on measurement 1
set low signal threshold 50057 50137 R/W set low signal threshold for auto val on
measurement 1