Servomex 07931001B, Operator'S Manual

Page: 52 / 221

38
© Servomex Group Limited. 2020 07931001B revision 6
4. Configuration
4.1 User settings
Network settings
You must configure the network settings to suit the requirements of the network you
have connected the analyzer to. Also see section 12 Appendix Modbus setup.
The values are Supervisor password protected. The analyzer supports IPv4 Mode
and IPv6 Mode. See your network administrator to confirm which mode and the
parameters to be entered.
To configure network settings
Figure 4-1: Network settings sequential menu
Note: The IPv4 or IPv6 address must be set to a unique value in the network
Menu Set Up User Settings Network Settings
Calibrate Manage Analyser Network Settings DHCP (Dynamic) + Static
Data Log mA Input Password Static select mode
Alarms mA Output Clock DHCP (Dynamic)
Status Relay Setup Regional
Set Up Filtering Display Setup
Measurements Unit Select Backlight
Service X-Interference Brightness
Clipping Save Current Config
User Settings Restore Config
Delete Config
Save Support Package
Media
fe80:0000:0000:0000
Information 021e:c0ff:fefc:c612
Hostname Servomex_000
edit
IPv6 Address
edit address
IPv4 Gateway 000.000.000.000
IPv4 Subnet Mask 255.255.240.000
edit address
IPv4 Mode
Default
IPv6 Mode
IPv4 Address 192.168.240.101