Servomex 07931001B, Operator'S Manual

Page: 175 / 221

07931001B revision 6 © Servomex Group Limited. 2020
161
Step 4 When all adjustments are complete, tighten the 4 M10 set screws in
order to lock the position
Note: Depending on application details it may be required to readjust the
photodiode DC level several times to ensure the target DC voltage
level does not exceed 2.7 volts. To check the DC voltage level refer to
4.11.1.
Note: The receiver alignment LEDs can only be used when the receiver is fitted with an
adjustable mount (not a fixed mount), and you are adjusting the mount at the
receiver end.
Figure 7-29: Installation: adjust laser intensity on the photodiode
1
Aligned
–
tuning target voltage met
4
Shows LASER power ON. LASER hazard
2
Large improvement
5
Small misalignment
3
Small improvement
6
Large misalignment