Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Vehicles with coolant bearing support, screwed
– Unscrew the screws -2- of the radiator mounting bracket -1-
right and left.
Continued procedure for all vehicles
– Press cooler on the top edge in the direction of the engine.
– Unhook radiator from the lower supports and press back‐
wards.
– Press catches -1- on both sides in -direction of arrow A- to
release them.
– Pull condenser -3- in -direction of arrow B-, and detach it from
charge-air cooler -2-.
– Tie up condenser on lock carrier.
– Lift water radiator for charge air cooling circuit -1- at bottom
out of radiator mountings -arrows-.
– Remove water radiator for charge air cooling circuit.
Installation
Install in the reverse order of removal, observing the following:
Note
♦
If there are minor dents in the fins, refer to respective instruc‐
tions
♦
Renew O-rings after removal.
León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
184
Rep. gr.19 - Cooling
