Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
♦ Assembly tool - T10487-
♦ Release tool - T10527- and release tool - T10527/1-
♦ Screwdriver with minimum shaft length of 250 mm (not illus‐
trated)
Work sequence
Rotate crankshaft to “TDC” as follows:
– Set piston in cylinder no. 1 to TDC position.
⇒ “2.3 Checking distribution timing”, page 84
– Remove plug, and loosen securing bolt of camshaft adjuster
on inlet side by approx. one turn.
⇒ “3.3 Removing and installing camshaft adjuster”,
– Loosen securing bolt of toothed belt pulley on exhaust side by
approx. one turn
⇒ “3.4 Removing and installing toothed belt pulley”,
.
– Loosen securing bolt of tensioning roller -1- using insert tool,
13 mm - T10500- .
– Release tension on tensioner at eccentric -2- using wrench -
T10499- .
– Detach toothed belt from camshaft sprockets.
Installation
León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
2. Toothed belt drive
91
