Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Screw 2 studs a few turns into holes -arrows-.
Note
Observe use-by date of sealant.
– Cut off nozzle of tube at front marking (nozzle ∅ approx. 1.5
mm).
Note
♦
Danger of blocking lubrication system with excess sealant.
♦
Do not apply sealant bead thicker than specified.
– Apply bead of sealant -arrow- onto clean sealing surface of oil
separator as shown in illustration.
• Width of the sealant line: 2 mm
The oil separator must be installed within 5 minutes after applying
the sealant.
– Place oil separator over studs and support on engine block.
– Unscrew studs again.
– Tighten bolts to specified torque observing specified tightening
Remaining installation sequence carried out in reverse sequence;
note the following:
– Install front noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Removing and installing noise
insulation .
Specified torques
♦
⇒ Fig. ““Oil separator - tightening torque and sequence”“ ,
♦
⇒ “2.2 Exploded view - electric coolant pump”, page 159
León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
142
Rep. gr.17 - Lubrication
