Seat Leon 2013, Workshop Manual

Page: 64 / 279

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Tighten nut -B- on assembly tool - T10134- to 40 Nm.
– Check the sender wheel installation position on the crankshaft
again ⇒ page 57 .
– Tighten nut on assembly tool - T10134- to 45 Nm if distance
is too small.
– Check the sender wheel installation position on the crankshaft
again ⇒ page 57 .
Assembling
– Tighten bolts for sealing flange (vehicles with manual gearbox)
⇒ page 50 .
– Install oil pan
⇒ “1.3 Removing and installing sump”, page 130 .
– Install intermediate plate (vehicles with manual gearbox)
⇒ page 50 .
– Install flywheel (vehicles with manual gearbox)
⇒ “2.2 Removing and installing flywheel”, page 50 .
Specified torques
♦
⇒ page 50
♦ ⇒ “2.1 Exploded view - cylinder block, gearbox end”,
page 49
♦ ⇒ “1.1 Assembly overview - ignition system”, page 268
♦ ⇒ “1.1 Exploded view - sump/oil pump”, page 126
♦ ⇒ General body repairs, exterior; Rep. gr. 66 ; Noise insula‐
tion; Assembly overview - noise insulation
♦ ⇒ Rep. gr. 34 ; Removing and installing gearbox; Tightening
torques for gearbox
León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
58
Rep. gr.13 - Crankshaft group