Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Remove resonator for intake air
⇒ “3.3 Removing and installing resonator for intake air”, page
– Free air hose from air pipe.
– Open hose clips -arrows-, and remove air hose -1-.
– Pull connector off charge pressure sender - GX26- .
Note
Make sure to use the new tools to prevent the locking lugs of the
air intake pipe from breaking off.
– Remove air intake pipe
⇒ “2.2 Removing and installing the air intake pipe”,
.
– Press release buttons and disconnect hose -1- leading to ac‐
tivated charcoal filter.
– Seal all openings in charge and intake air system using plugs
from engine bung set - VAS 6122- .
Note
♦
The bolts -arrows- must be renewed.
♦
Thoroughly clean thread on turbocharger.
– Remove bolts -arrows- and detach crankcase breather hose.
– Move clear electrical wiring harness -arrows-.
– Unscrew bolts -1, 3- and remove cover -2- for toothed belt for
coolant pump.
– Move clear electrical wiring harness -1- and coolant hose -2-.
– Loosen the hose clips -arrows-, remove the coolant hoses.
León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
2. Coolant pump/thermostat assembly
163
