Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Release fastener -arrow- and detach engine control unit -1-.
– Release and unplug connectors for engine control unit - J623- .
Installation
Installation is carried out in the reverse order. Please note the
following:
– Make sure you fit protective housing back on engine control
unit - J623- .
– Clean threaded holes for shear bolts to remove any residue
from locking fluid. This can be done using a thread tap.
– Use new breakaway bolts.
After installing a new engine control unit, the following operation
must be performed:
– Connect vehicle diagnostic tester .
– Activate engine control unit with the function “Replace engine
control unit” on vehicle diagnosis tester in “Guided functions”
mode.
León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
244
Rep. gr.24 - Mixture preparation - injection
