Ryobi RCS5133CB, Original Instructions Manual

Page: 12 / 324

10 | English
Use 2-stroke oil for air cooled engines.
Mix the fuel mix thoroughly and also
each time before refueling.
Add bar and chain oil every time you
add fuel to the chainsaw.
CE conformity
EurAsian Conformity Mark
Ukrainian mark of conformity
Guaranteed sound power level is 114
dB.
Set the chain brake to the "run" position.
Set the chain brake to the "brake"
position.
Turn the ignition switch to the "on"
position.
Fully press and release the primer bulb
at least 10 times.
Pull the choke lever all the way out the
full-choke position.
Pull the starter rope until the fi rst fi ring
of the engine is heard (no more than
fi ve pulls).
Push the choke lever all the way in.
Pull starter grip until the engine starts.
Depress the trigger release and squeeze
the throttle trigger, then release the
throttle trigger to return the engine to
idle.
Allow the product to run idle for 15 - 30
seconds.
Fuel and oil
Bar and chain lubricant
Rotate to adjust chain tension
+ = Tighten the chain
- = Loosen the chain
Moving direction of the chain
H = High speed adjustment needle
L = Low speed adjustment needle
T = Idle adjustment screw
Lock the fi lter access cover.
Unlock the fi lter access cover.
Set the ignition switch to the "stop"
position.
SYMBOLS IN THIS MANUAL
Mix fuel outdoors where there are no
sparks or
fl ames.
Do not smoke when mixing fuel or fi lling
fuel tank.
Parts or accessories sold separately
Note
Warning
Wear eye and face protection.
Wear upper body protection.
Wear leg protection.