RS Automation OEMax CSD7, User Manual, Page: 47 / 332

Wiring
3-9
CSD7 Servo Drive (EtherCAT)
Using Method of Socket and Lever
This section describes how to use wiring socket and lever provided
with servo drive.
•
Connect only one wire to the wire inlet of the socket.
•
If the wire is pulled accidentally with an excessive force,
reconnect the wire after trimming it properly.
•
The peeled wire can be used. (Keep the length of the peeled
core wire less than 8 [mm].)
•
The use of phenol terminal is recommended for the reliability of
wiring.
•
After connecting the wire, pull it slightly to check if the
connection between the socket and wire is normal.
•
You can disconnect the wire by pressing the button at the top of
the socket.
The thickness of wire allowed by the socket is shown below.
Table 6 Thickness of wire
Rated Power Wire Thickness
400W and less AWG26 ~ AWG14 (Stranded Wire)
800W and above AWG20 ~ AWG14 (Stranded Wire)
Press the terminal with
crimping tool for phenol
terminal
NOTE : Keep the length of
the peeled wire less
than 8mm
Terminal
Wire
Socket