Ricoh InfoPrint 4100 TD3, Operating Manual

Page: 86 / 462

Removing forms
Before you begin
If forms are loaded in Printer 1, you must remove them from the printer before
doing this procedure.
About this task
Do this procedure to remove the forms from the printer.
Procedure:
Procedure
1. Open the center front and center top covers of the printer.
2.
For fanfold forms, separate the forms at a perforation near the splicing table.
3. Let the forms fall back into the input area but ensure that the end-of-forms
sensor is not covered by the forms in the input area.
4. Select Advance Paper (NPRO) on the touch panel, or press NPRO on the
operator panel of either printer. The 078A
END OF FORMS
message appears on
the touch panel.
5. Select or press NPRO again. The forms move through the printers to the forms
exit area or to a postprocessing device.
Loading tractored roll-feed forms
Before you begin
Before doing this procedure, ensure that the center front and center top covers of
the printer are open so that you can access the forms input area and the transfer
station.
If forms are loaded in Printer 1, you must remove them from the printer before
doing this procedure. See “Removing forms” for instructions.
About this task
This procedure describes how to load tractored, roll-feed continuous forms that are
loaded at the input area of the printer and processed through to the output area of
the printer. Figure 36 on page 71 illustrates the paper paths to use when loading
tractored roll-feed forms.
Note: If you are using preprocessing or postprocessing devices with the printer,
some steps involving the source and final destination of the forms may change.
The provider of the preprocessing or postprocessing devices supplies specific
instructions for the initial loading and exiting of forms from the printer output
area.
Because you will be working inside the printer covers, we recommend that you
use the printer operator panel of the affected printer whenever possible, especially
while working on Printer 1.
72
Operating the InfoPrint 4100