Ricoh InfoPrint 4100 TD3, Operating Manual

Page: 178 / 462

v
You cannot auto-align if you are using the UP
3
I intelligent pre- and
postprocessing interface.
v
You must have the Side 2 Verify function enabled unless you are using
tractorless paper.
v
Forms cannot be less than 3 inches in length.
v
Auto-align of a duplex system cannot be done if the system is out of paper.
Procedure:
Procedure
1.
Select
Forms → Align Forms
.
2.
Ensure that forms are properly threaded through Printer 1 and Printer 2.
3. Select Printer 1 Aligned on the Align Forms panel after you have visually
verified that the forms are aligned. This activates the Align Printer 2 function.
4. Select Align Printer 2 .
a. Printer 1 prints a page with a dashed line (1) . It also prints one or more
pages of arrows (2) on both sides of the line pointing towards it.
b. Printer 1 then prints a solid alignment mark on the alignment page. A
one-bar or two-bar pattern is also printed on the alignment page to show
whether Side 1 or Side 2 of the form is printed on Printer 1.
c.
A fixed length of forms is fed through both Printer 1 and Printer 2. This
length is based on the "Printer 1 to Printer 2 Distance" configuration item
set in the Printer - Setup panel (
Printer Definition
→
Printer
→
Setup ).
9:56
6/28/11
Figure 63. Align Forms panel
164
Operating the InfoPrint 4100