Ricoh InfoPrint 4100 TD3, Operating Manual

Page: 101 / 462

v
If the forms now loaded in the printer are different from the forms that were
used last, see “Checking print quality” on page 190.
v
If preprinted forms are now loaded in the printer and you want to check or
adjust the registration, see “Setting print registration” on page 129.
v
If you are loading both printers in a Duplex system, you will need to load
Printer 1 and align the forms on Printer 1, then load Printer 2 and align the
forms on Printer 2. Depending on the type of form you are loading, refer to
“Aligning tractored forms” on page 155 or “Aligning tractorless forms” on page
163.
Loading tractored fan-fold forms
Before you begin
Before doing this procedure, ensure that the center front and center top covers of
the printer are open so that you can access the forms input area and the transfer
station.
If forms are loaded in Printer 1, you must remove them from the printer before
doing this procedure. See “Removing forms” on page 72 for instructions.
About this task
This procedure describes how to load tractored, fan-fold forms that are loaded at the
input area of the printer and processed through to the output area of the printer.
Figure 36 on page 71 illustrates the paper path to use when loading tractored
fan-fold forms.
Note: If you are using preprocessing or postprocessing devices with the printer,
some steps involving the source and final destination of the forms may change.
The provider of the preprocessing or postprocessing devices supplies specific
instructions for the initial loading and exiting of forms from the printer output
area.
Because you will be working inside the printer covers, we recommend that you
use the printer operator panel of the affected printer whenever possible, especially
while working on Printer 1.
Chapter 5. Working with forms
87