Ricoh InfoPrint 4100 TD3, Operating Manual

Page: 252 / 462

Clearing a forms jam between Printer 1 and Printer 2
About this task
A jam occurring between Printer 1 and Printer 2 normally causes the forms to tear
and separate. Both Printer 1 and Printer 2 continue to feed forms and print until
an error condition is detected and displayed. A large supply of forms may be
present on the floor at the output of Printer 1.
Procedure:
Do this procedure to clear a forms jam between Printer 1 and Printer 2.
Procedure
1. Do not flush any forms out of either printer.
2.
Manually pull the forms through the buffer/flipper unit under Printer 2 and up
into forms input area of Printer 2.
3. Begin the “Align Forms” procedure ( Forms
→
Align Forms ). If necessary, select
the appropriate paper advance (feed page) key on the Align Forms panel or on
the printer operator panel, to feed enough forms to splice (at the Printer 2
splicing table) the forms from the buffer/flipper unit to the forms remaining in
the Printer 2 path.
4. Make sure all interventions have been cleared. As necessary, follow the
recovery instructions to clear any active interventions.
5.
Complete the “Align Forms” procedure.
6. Select Start on the printer operator panel or on the Main touch panel.
Related tasks
“Aligning forms when forms are broken between printers” on page 160
Clearing a forms jam between the printer and a
postprocessing device
About this task
A jam or separated form that occurs between the postprocessing device and the
printer is not detected and presented as a form jam. The usual error condition
presented is error message D204
PRE/POST NOT READY LINE BECAME ACTIVE
on the
touch panel or error message D204
PRINTER ERROR
on the affected printer operator
panel. This error message occurs when the Pre/postprocessor Busy Timer included
in the characteristics section of an installed and enabled postprocessing device has
timed out. (Refer to the
Planning and Configuration Guide for details.)
Procedure:
238
Operating the InfoPrint 4100