Ricoh InfoPrint 4100 TD3, Operating Manual

Page: 41 / 462

Selecting This Control: Does This:
FORMS WIDTH This control is not active on InfoPrint 4100 Models TS3
and TD5/6.
On InfoPrint 4100 with the stacker installed, this control
increases or decreases the stacker forms width setting.
The
FORMS WIDTH lever should be set to the position
that corresponds to the forms width shown on the
stacker LED display (14.0 in the above illustrations).
FORMS LENGTH
Displays the current forms length and lets you adjust it.
On InfoPrint 4100 with the stacker installed, this control
increases or decreases the stacker forms length setting.
Figure 20 shows a forms length setting of 8 2/3. To use
the stacker, set the FORMS LENGTH on the stacker
control panel between 7 and 14, or 7 and 17 inches.
Note: If you are not using the stacker, you must still set
the forms length to allow Auto Load to function
correctly.
DOWN
UP
TABLE
STOP
STOP
7 8 9 10 11 12 13 14
0 1/3 1/2 2/3
18 17 16
15
14 13
12
8
11 19
FORMS LENGTH
TABLE
READY
FORMS WIDTH
IC3U0010
Figure 20. Stacker control panel on InfoPrint 4100 models
Chapter 1. Introducing the printer
27