Ricoh InfoPrint 4100 TD3, Operating Manual

Page: 67 / 462

Simplex configuration and installed but disabled on Printer 2. The installed and
enabled state of protocols is not changed by a system restart or a
shutdown/startup sequence.
After a protocol is enabled on a printer, commands may be entered on a host
system that communicates with that printer.
Enabling and disabling pre/postprocessors
Before you begin
If you change the enabled status of a burster/trimmer/stacker (BTS) or an offsetter
postprocessing device, you must make configuration changes on the
Pre/Postprocessing panel (
Printer Definition
→
Pre/Postprocessing ). See the
Planning and Configuration Guide for more information.
For all other types of postprocessing devices and for all preprocessing devices, you
can make status changes only using the
Enable and Disable options on the
Pre/postprocessors panel ( Frequent Tasks
→
Pre/Postprocessors ).
About this task
The service representative configures any attached preprocessors and
postprocessors when they are installed and sets the state of each device to Enabled
or Disabled.
Procedure:
Do this procedure to functionally connect (enable) the printer to the processor or
disconnect (disable) the printer from the processor.
Procedure
1. On the Main touch panel, select Frequent Tasks → Pre/Postprocessors .
2. Select a processor in the Processor Name list. The status displays next to the
processor.
3.
Select
Enable
or
Disable
.
Note:
The internal stacker feature is supported on InfoPrint 4100 in Simplex
mode only, and on in Dual Simplex mode only. When the internal stacker is
enabled on printers, the printer speed must be set to
Low . Select Low for the
Printer Speed option on the Printer - Basic panel ( Printer Definition
→
Printer
→
Basic ).
Canceling a job
About this task
Procedure:
Do this procedure to cancel a job.
Procedure
1. On the Main touch panel or printer operator panel, select Stop to stop the
printers.
Chapter 3. Operating the printer
53