Ricoh InfoPrint 4100 TD3, Operating Manual

Page: 112 / 462

About this task
Procedure:
Procedure
1. Select Forms
→
Form Settings to display the Form Settings panel.
2. If the name listed in the Form Name field contains the form definition you
want to load, select Cancel .
3. If the name listed in the Form Name field does not contain the form definition
you want to load, do the following:
a. Ensure that the length and width values are correct.
b.
Select Frequent Tasks
→
Snapshots . You see a list of the currently defined
Snapshots.
c. If you are loading a Snapshot that has been previously defined, select the
Snapshot you want to load from the
Saved Snapshots area, and select Load .
Note: If the Snapshot is not defined, see Chapter 4, “Working with Snapshots,”
on page 61 for more information about defining Snapshots.
What to do next
If you are using the Auto Load sequence to load the forms, you must set the forms
length at the stacker control panel. See “Setting the forms length for Auto Load”
on page 134. If you are loading the forms manually, see “Loading forms using the
Forms Feed button” on page 82.
9:56
6/28/11
g5aud258
Frequent
Tasks
Forms
Maintenance
Printer
Definition
Logon...
Units
mm
in
Width
11.0
18.0
Length
Form Name
0
0
2UpLetter
Form Bar Code
Align Forms
Form Settings
Help... OK
Start Stop Check/Reset
Tractorless
Marks...
Oversize paper
No
Paper Weight
75 - 98 gsm (20 - 26 pounds)
Cancel
Advance
Paper (NPRO)
Shutdown
Print
Registration
Print
Registration
IPDS
Advance
Paper (NPRO)
Special Marks
Tractorless (Tractored
Forms)
Host Setup
Id
Enable NO
Commercial Print
Figure 42. Form Settings panel
98
Operating the InfoPrint 4100