Ricoh InfoPrint 4100 TD3, Operating Manual

Page: 157 / 462

Note: If the Tractorless Steering Assembly (RPQ 8B5010) is installed on the
tractorless pressure roller assembly, you can turn the knob to adjust the
steering in case of forms jams.
6. Close the gate (5) .
7.
If there is a Universal Forms Control (UFC) sensor, thread the forms from the
forms input area and up to the or splicing table (if installed), as follows:
a. Open the tension gate.
b.
Thread the forms through the tension bars and rollers, leaving the tension
gate and roller open.
c. Thread the forms over the forms guide.
d. Rotate open the UFC sensor and thread the form under the UFC shafts.
8. Adjust the rear paper-edge guide as follows:
a. Loosen the thumbscrew (2) .
b. Slide the rear paper-edge guide (1) to the correct location for the current
paper width. The paper should be positioned against the vertical surface of
the guide
(3)
so that the sensor on the bottom side of the sensor mounting
plate can read side verify marks and registration marks, which are printed
on the outside edge of the paper. The edge guide is also used to guide the
paper in tractorless mode.
g6am0020
1
2
6
4
3
5
Chapter 5. Working with forms
143