Ricoh InfoPrint 4100 TD3, Operating Manual

Page: 226 / 462

For Printer 2, the marks may be preprinted on the form or printed on the form by
Printer 1. If they are preprinted, they must be enabled using the Marks window as
described for Printer 1 above. If the marks are printed by Printer 1, they can be
enabled using the Edit window.
Note: When printing on tractorless forms, the registration mark must be
positioned so that it can be read by the toner mark/side verify sensor. For this
reason, you should specify a value for
Offset that will restrict the placement of the
mark to ensure that it will be read by the sensor.
Procedure:
Procedure
1. Select Forms
→
Special Marks to display the Special Marks panel.
2.
Select Registration Marks for Tractorless Printing in the Special Marks
window.
3. If you want to make changes to the registration mark, select Edit... to display
the Edit window and use the following fields to change the size or location of
the mark.
v
In the Enabled field, select the printer you want to print the mark (usually
Printer 1).
v Across Paper Feed Direction provides options to set the width of the mark,
the alignment of the mark relative to the front or back edge of the form, and
the offset relative to the alignment value.
v
Paper Feed Direction provides options to set the height of the mark and the
placement of the mark relative to the top of the form.
4.
Select OK to save your changes.
Note: When Same Side Printing is set to Yes for duplex data , the registration
mark is automatically positioned to an equivalent position on the opposite side
of the page so that the mark can be read by the sensor. This could change the
mark alignment position and its offset value in the
Across Paper Feed
Direction .
Using registration marks for top of form
Before you begin
About this task
Do this procedure to define or specify registration marks used to register the top of
the form. Use the Edit window to change the size and location of the mark.
When using the top-of-form registration mark, a short line is printed at the front
edge of the form to indicate the leading edge or top of the form. This mark is used
primarily by printer operators or to align the paper in a post processor for cutting
and separating the forms at the correct point. You can use this option to indicate
the leading edge on perfless paper.
Note:
Registration marks are placed relative to the physical edge of the form to
allow printing the mark in the tractor strips on tractored forms. The marks can be
printed in the same location on tractorless forms. See “Selecting the Universal
Forms Control (UFC) sensors” on page 198 or “Using the Dual Toner Mark/Side
212
Operating the InfoPrint 4100