Ricoh InfoPrint 4100 TD3, Operating Manual

Page: 113 / 462

Loading forms using the Forms Feed button
Before you begin
Hold the tension arm so that it stays aligned with the blue mark on the guide
notch while you do the following steps. Otherwise, the 079A
CHECK TENSION ARM
079A
message appears when you turn on the forms path vacuum, and you must do
the Check Tension Arm procedure.
About this task
Do this procedure to manually load the forms using the Forms Feed button on the
printer control panel.
Procedure:
Procedure
1. Open all paper guides, tractor units, and feeding units to their widest position
in both Printer 1 and Printer 2:
v
Use the Tractor Control Knob (6) to adjust the tractors to the widest possible
width. Use the scale just to the left of the tractor covers.
v Adjust the tractorless feeding unit (drive roller, pressure roller, and vacuum
belt unit slots
(1) ) to the widest position.
v
Adjust all tractor units to the outermost position. To adjust a unit, press the
blue button
(5) while grasping the unit and slide the unit to the outermost
position.
Note: Make sure the tractor slot (2) is in the Tractorless Feed mode (3) .
Position (4) is Tractor Feed mode.
Chapter 5. Working with forms
99