Ricoh InfoPrint 4100 TD3, Operating Manual

Page: 209 / 462

the stacker needs to be emptied more often as the stack height and weight are
reduced. To adjust the stacker table, see “About the forms exit area” on page
23.
Using the printer stacker with a postprocessor
About this task
Note: This procedure applies only to InfoPrint Models MS1 and HS2 with the
internal stacker feature installed.
If a postprocessing device is disabled or not yet configured, you may continue to
use boxed forms and the printer stacker. If the postprocessing device includes any
rollers, sensors, or any other hardware that would interfere with the operation of
the stacker, you must remove those interferences before you attempt to use the
stacker.
If the Use Internal Stacker configuration item on the Postprocessing Options panel
( Printer DefinitionPre/Postprocessing
→
Postprocessing Options panel is set to
Yes and there are no postprocessing devices installed and enabled on the printer,
the stacker table automatically rises when printing begins. To raise the stacker table
manually, press the table
UP switch on the stacker control panel.
Note:
When the internal stacker is enabled on HS2 printers, the printer speed must
be set to low speed. Refer to “Switching printer speeds” on page 60 for
instructions on changing the printer speed.
If a postprocessing device is installed on a printer and is enabled, the stacker table
is lowered and is prevented from moving upward. The pendulum and other
devices in the stacker are also prevented from operating.
In Duplex mode, the stacker (if installed) in Printer 1 is always disabled as if a
postprocessing device were installed and enabled.
Attention: Printing to the internal stacker is not supported in duplex mode.
Verifying synchronized duplex printing for tractored forms
About this task
The Side 1/Side 2 Verify feature automatically checks to make sure that the duplex
printing system is properly aligned and the printing on both sides of the forms is
synchronized. If the verification system detects that the data to be printed on Side
2 does not synchronize with the data printed on Side 1, or if it detects the printing
alignment from Side 1 to Side 2 is off by more than 4.2 mm (1/6th inch), it stops
the printer and displays an error on the touch panel.
Chapter 5. Working with forms
195