Raven SmarTrax MD, Calibration & Operation Manual, Page: 78 / 136

C
HAPTER
5
72 SmarTrax™ MD Calibration & Operation Manual
The current status of the SmarTrax MD system can be determined by the icons displayed on the field computer
screen.
INITIAL STARTUP
CRUIZER II - CONNECTING TO SMARTRAX MD VIA CAN COMMUNICATION
1. Select the Tools Menu icon on the main menu.
2. Select the Show All icon in the upper-right corner of the screen.
3. Change the Port B baud rate to 115,200.
NOTE: Press the down arrow until 115,200 is displayed, then tap it to highlight it in blue.
Display Message
The SmarTrax node is detected, but no guidance line has
been set or there is an error in the system.
The SmarTrax node is detected and turned on, but the
current speed is outside of the acceptable operating
range.
SmarTrax MD is detected and turned on, with no errors
detected.
SmarTrax MD is detected and turned on, but is not
enabled. Tap the foot switch or touch the steering wheel
icon to enable the SmarTrax MD system.
SmarTrax MD is detected and in engaged, with no errors
detected.
Previous - Returns the Envizio Pro or Cruizer display to
the previous screen in the setup process.
Next - Saves the changes made to the SmarTrax MD
system and proceeds to the next step in the setup
process.
Accept - Saves the changes made to the SmarTrax MD
system at the end of the setup process and returns the
to the Tools Menu.
Exit - Exits from the current screen without saving any
changes made to the system.