Raven SmarTrax MD, Calibration & Operation Manual

Page: 7 / 136

CHAPTER
1
P/N 016-5030-020 Rev. D 1
CHAPTER 1
IMPORTANT SAFETY
INFORMATION
Read this manual and the operation and safety instructions included with your implement and/or controller
carefully before installing the SmarTrax MD™ system.
• Follow all safety information presented within this manual.
• If you require assistance with any portion of the installation or service of your Raven equipment, contact your
local Raven dealer for support.
• Follow all safety labels affixed to the SmarTrax MD system components. Be sure to keep safety labels in good
condition and replace any missing or damaged labels. To obtain replacements for missing or damaged safety
labels, contact your local Raven dealer.
When operating the machine after installing SmarTrax MD, observe the following safety measures:
• Be alert and aware of surroundings.
• Do not operate SmarTrax MD or any agricultural equipment while under the influence of alcohol or an illegal
substance.
• Remain in the operator’s position or a safe working distance away from the booms at all times when SmarTrax
MD is engaged.
• Disable SmarTrax MD when exiting from the operator’s seat and machine.
• Do not drive the machine with SmarTrax MD enabled on any public road.
• Determine and remain a safe working distance from other individuals. The operator is responsible for disabling
SmarTrax MD when the safe working distance has diminished.
• Ensure SmarTrax MD is disabled prior to starting any maintenance work on SmarTrax MD or the machine.
GENERAL
• Always verify that the power leads are connected to the correct polarity as marked. Reversing the power leads
could cause severe damage to the equipment.
• Ensure that the power cable is the last cable to be connected.
• A minimum of 12 VDC is required for system operation with a maximum of 15 VDC.
NOTICE
CAUTION