Raven SmarTrax MD, Calibration & Operation Manual, Page: 65 / 136

4
P/N 016-5030-020 Rev. D 59
VIPER PRO CALIBRATION AND OPERATION
FIGURE 29. Steering Calibration Resume Screen
If the wheels strike the stops at the end of travel or if a high degree of effort is required to turn the wheels during
calibration, steering may be disengaged. If steering becomes disengaged during calibration:
• Press
Stop to cancel the calibration. Adjust the amount of effort required to disengage the steering system by
pressing the Adjust Switch button.
• Press Retry to return to the calibration process. Retry is most commonly used when the system is intentionally
disengaged to avoid obstacles.
COMPLETE THE SMARTRAX MD CALIBRATION PROCESS
NOTE: The Line Acquire Aggressiveness and On-Line Sensitivity values may be adjusted to further tune the
system or to adjust for operating conditions. Refer to the Advanced Setup Tools section below for
further information on system adjustments.
NOTICE
The calibration of the machine’s steering system
should be performed in a field or other large,
open space and during conditions similar to
normal vehicle operation.
If the ground or surface is slippery, muddy, or
freshly tilled, the SmarTrax MD system may learn
incorrect steering responses for normal
operating conditions.
Ensure the machine’s hydraulics are operating
properly and there are no other mechanical
issues that may affect the performance of the
SmarTrax MD system.