Signal Generator Settings
R&S
®
SGT100A
241
User Manual 1176.8674.02 ─ 07
Remote command:
[:SOURce<hw>]:BBIN:ALEVel:EXECute
Crest Factor
Sets the crest factor of the external analog or digital baseband signal. Indicates the
crest factor acquired with "Auto Level Set".
Remote command:
Peak Level
Enters the peak level of the external digital baseband signal relative to full scale of 0.5
V (in terms of dB full scale).
Indicates the peak level acquired with "Auto Level Set".
Remote command:
Level
Indicates the estimated rms level acquired with "Auto Level Set".
Remote command:
Signal Monitoring
The section "Signal Monitoring" indicates an overload.
Overflow
Indicates that the I/Q input is currently overloaded.
If overload is indicated either the amplitude of the external signal is too high (full scale
of 0.5 V) and must be reduced or the entered "Peak Level" (in dB full scale) value does
not correspond with the real value and must be corrected. It also can be evaluated
automatically with button "Auto Level Set".
Remote command:
[:SOURce<hw>]:BBIN:OLOad:STATe?
Overflow Hold
Indicates an overload since last reset for evaluating the measurement.
The Overload Hold state can be reset via the "Reset" button next to the LED, or is
reset automatically by starting a new measurement ("Auto
Level Set") or by setting
new values (Crest Factor, Peak Level, Level).
Remote command:
[:SOURce<hw>]:BBIN:OLOad:HOLD:STATe?
Reset
Executes a reset of the "Overflow Hold" state.
Remote command:
[:SOURce<hw>]:BBIN:OLOad:HOLD:STATe?
External Baseband Signal - Baseband Input