R&S SGT100A, User Manual

Page: 68 / 593

First Steps with the Instrument
R&S
®
SGT100A
37 User Manual 1176.8674.02 ─ 07
4 First Steps with the Instrument
This chapter introduces the most important functions and settings of the R&S SGT step
by step.
Prerequisites
As a prerequisite for these examples, the R&S SGT has to be connected to a remote
PC. The R&S SGMA-GUI software has to be installed on this remote PC and the
instrument is added to the list of "Available Instruments".
For information on how to fulfill these requirements, refer to:
●
Chapter 2.3.2.1, "Connecting the Instrument to the Network" , on page 26
●
Chapter 2.3.1, "Installing the R&S SGMA-GUI Software on an External PC" ,
on page 25
●
Chapter 2.3.2.3, "Automatically Adding Instruments to the SGMA-GUI " ,
on page 27
● How to Generate a CW Signal ................................................................................37
● How to Create a Waveform File with R&S WinIQSIM2 and Load it in the ARB ......39
4.1 How to Generate a CW Signal
Configuring the R&S SGT to generate a CW signal
Figure 4-1: Example of the setup
1. Check the front panel of the R&S SGT.
The POWER ON/STAND BY key has to be green .
2. On the connected remote PC, start the R&S SGMA-GUI software application.
How to Generate a CW Signal