Qualstar XLS Series, Technical & Service Manual

Page: 316 / 366

17.5 Restarting the XLS if the Hardware Configuration was Changed
17-12
501610 Rev. 07-01-19
14. As required, put the XLS in logical mode. See Section 5.4.4 on page 5-11 .
17.5 Restarting the XLS if the Hardware Configuration was
Changed
This section includes instructions for applying power to the XLS, updating the hardware
configuration, and scanning fiducials and cartridges. Use the instructions in this section if
you opened one or more doors when the XLS was shut down
and changed the hardware
configuration. For example, you would use these instructions after performing any of the
following procedures:
•
Replacing a drive bay with a cartridge bay (or vice versa)
•
Replacing a fixed port assembly with an I/O port (or vice versa)
•
Installing or removing door slots
Important:
• If you installed a MEM, refer to
Section 15.1,
“ Installing a MEM ,” on page 15-1
.
• If you installed an expansion pod (XLS-812300), refer to
Chapter 16, “Installing an Expansion Pod.”
17.5.1 Applying Power
To apply power if one or more doors were open when the XLS was shut down and a drive
bay, cartridge bay, I/O port, or door slots were installed or removed, follow these steps:
1. Leave at least one door open (the I/O ports can be open or closed).