![Qualstar XLS Series Technical & Service Manual Download Page 230](http://html2.mh-extra.com/html/qualstar/xls-series/xls-series_technical-and-service-manual_3471239230.webp)
13.1
Replacing the Touch Screen Assembly
13-4
501610 Rev. 07-01-19
4.
Using a Phillips screwdriver, remove the five screws at the top and the sides of
the touch screen. See
Figure 13-3
.
Remove the 5
screws on the top
and sides
Loosen the 3
screws on the
bottom
Figure 13-3
Location of screws for the touch screen
5.
Loosen the three screws at the bottom of the touch screen.
6.
Slide the touch screen up and remove it from the front panel.
13.1.2 Installing the Touch Screen Assembly
To install the touch screen, follow these steps:
1.
Lean the front panel against a wall.
2.
Slide the touch screen into position, making sure to align the notches on the
bottom of the touch screen with the three screws.
3.
Replace the five screws on the sides and top of the touch screen.
4.
Tighten all eight screws around the edges of the touch screen.
5.
Reattach the four cables. See
Figure 13-2 on page 13-3
.
6.
Replace the front panel. See
Section 10.2 on page 10-7
.
7.
Apply power to the XLS. See
Section 17.4.1 on page 17-8
.
Summary of Contents for XLS Series
