Qualstar XLS Series, Technical & Service Manual

Page: 268 / 366

15.1 Installing a MEM
15-14
501610 Rev. 07-01-19
4. Turn the carousel support another 1/4 to 1/8 of a turn until it is tight against the
floor.
5. Using a 3/4-inch open-end wrench, turn the jam nut clockwise until it pushes up
against the frame. See Figure 15-16 on page 15-13 .
6. Repeat steps 2 – 5 to extend the back carousel support.
15.1.8 Installing the Side Panel on the MEM
To install the side panel on the MEM, follow these steps:
1. Holding the side panel with both hands, place the panel next to the MEM and
carefully lower it until the hooks on the panel engage with the corresponding
slots on the
MEM’s frame.
2. Insert the two screws in the holes at the bottom of the panel. See Figure 15-18 .
Figure 15-18 Installing the side panel on the MEM
3. Using a #2 Phillips screwdriver, tighten the screws.
15.1.9 Applying Power
To apply power after installing a MEM, follow these steps:
1. Leave at least one door open (the I/O ports can be open or closed).