Qualstar XLS Series, Technical & Service Manual

Page: 141 / 366

9
Installing or Replacing Cartridge Slots and Drive Bays
XLS Library Technical Service Manual 9-
127
2. Open the door upon which you want to install door slots.
3. On the back of the door, locate the bracket with the DOR barcode label.
4. Using a Phillips screwdriver, remove the two screws attaching the bracket to the
door and remove the bracket. See Figure 9-3 .
Figure 9-3 DOR barcode label and bracket (back of door shown)
5. On the back of the door, locate the holes for the 11 magazine faceplates.
6. Insert three 6-32 x 5/16 flat-head screws through the outermost holes on a
magazine faceplate to attach the faceplate to the door. There are two holes on the
inside edge of the bracket, but you only need to use the lower hole. See
Figure 9-4 .
Figure 9-4 Attaching the magazine faceplate to the door
7. Using a Phillips screwdriver, tighten the screws.
8. Repeat steps 6 and 7 for the remaining magazine faceplates.