Qualstar XLS Series, Technical & Service Manual

Page: 169 / 366

10
Replacing Frame Components
XLS Library Technical Service Manual 10-
155
2. Raise the top of the air filter cover into position.
3. Tighten the captive screws.
10.2.4 Replacing the Cartridges
To replace the cartridges, follow these steps:
1. Reach in from the front of the library and replace any cartridges that were
located in the fixed slots behind the front panel.
2. Press the I/O port solenoids to open the I/O ports.
3. Replace the I/O port magazines.
4. Refer to Section 17.4 on page 17-8 to power on the library and scan the
fiducials and inventory.
CAUTION
If you replaced a fixed port assembly with an I/O port, follow the
instructions in
Section 17.5 on page 17-12 to restart the library. Do
not close the doors until you have updated the hardware configuration
in X-Link. Otherwise, hardware damage may occur when the I/O ports
are automatically scanned.
10.3 Replacing a Side Panel
This section provides instructions for removing the left or right side panel from the LRM
or MEM.
Required tools and equipment:
Make sure you have the following:
•
#2 Phillips screwdriver
10.3.1 Removing a Side Panel
To remove a side panel, follow these steps:
1. Shut down the library and power it off. See Section 6.2 on page 6-1 .
2. Locate the two Phillips screws at the base of the side panel.